Boost ECX3100A Manuál s instrukcemi Strana 9

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 18
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 8
9
boost
TM
EN
SHOCK CLEANING
Oil-filled shocks will require regular maintenance due to the •
oil breaking down or getting dirty. This maintenance should be
performed after about every 3 to 5 hours of use depending
on conditions that the vehicle is used in.
Remove the shock from the vehicle. •
Remove the cap from the shock body and dispose of fluid. •
Disassemble the shock. Clean thoroughly with DYN5505. •
Dry parts before assembly.
Assemble the shock and refill the shock body with silicone •
fluid (30 weight recommended).
Slowly move the shaft and piston up and down to •
remove air bubbles.
Move the piston to the midway point of the body and •
install the cap.
Wipe off any overflowing fluid. •
When properly filled, the piston should rebound about •
3/8 in (9.5mm) after being pushed in fully.
Install shock on vehicle.•
Ride Height Adjustment
Ride height is an adjustment that affects the way the vehicle
jumps, turns and goes over bumps. Drop one end of the vehicle
from approximately 6 inches (150 mm) in height onto a flat
surface. When dropping the front of the vehicle, after the vehicle
settles make sure the front arms are equal and parallel to the flat
surface. Do the same with the rear and look at the rear to make
sure both arms are parallel with the flat surface.
Lower the front ride height to increase steering. Lower the rear
ride height to increase traction but decrease steering.
Front ShockRear Shock
ECX1043
ECX1037
ECX1037
ECX3022
ECX1037
ECX1043
ECX1038
ECX3023
ECX3021
ECX3020
ECX3019
ECX1038
ECX1038
ECX1037
ECX1057
REAR SHOCK FRONT SHOCK
Part # Description
ECX3019 Shock Body Set
ECX1037 Shock Caps, Pistons
ECX1038 Shock Parts Set
ECX3020 Front Shock Shaft (2)
MAINTENANCE
Part # Description
ECX3021 Rear Shock Shaft (2)
ECX3022 Front Shock Springs (2)
ECX3023 Rear Shock Springs (2)
ECX1043 Shock O-Ring Set
Problem Possible Cause Solution
Short Run Time
•Batterydamaged/notcharged
•Motordirtyorbrushesworn
•Check/changebattery
•Check/clean/replace
Sluggish Action
•Motordirtyorbrushesworn
•Bindindrivetrain
•Vehiclebatteryisnotcharged
•Check/clean/replace
•Clean/adjust
•Replace/recharge
Controls Reversed •ST.REVorTH.REV •Changeswitchposition
Motor/ESC overheat •Over-geared •Installsmallerpinion
Doesn’t Operate
•Transmitterbatterieslow
•Transmitterpoweredoff
•ESCpoweredoff
•Vehiclebatteryisnotcharged
•Replace/recharge
•PowerOn
•PowerOn
•Replace/recharge
Poor Range
•Transmitterbatterieslow
•Transmitterantennaisdamagedorloose
•Receiverantennadamaged
•Motordirtyorbrushesworn
•Replace/recharge
•Check/tighten
•Check/repair/replace
•Check/clean/replace
TROUBLESHOOTING GUIDE
Zobrazit stránku 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Komentáře k této Příručce

Žádné komentáře